Here are some tips for the Expert Locksmith phoenix for the changing of the lock of
car. If you are a beginner and do not know how to change the lock of car
the you may find help after reading the following. First of all the
point which has no need to be mentioned is that you are going to open
the door with the broken lock. Along the edges of the door try to find
out he recessed holes around the edges of the door. To lose the
attachment Allen bolt a key is used named as Allen key available in the
market is used. Then you must remove the door panel from the inside.
Then the next step is the finding of door handle catch. To loose and
remove the attachment set screws use the small Phillip’ s screwdriver
which is best for it. Now pry out the handle and lock of your car door
with a gentle touch from the inside. Now call an assistant as it cannot
be done alone. Your assistant will push on the lock mechanism from the
outside of the door.
On the other side you are already pulling it inside. Now you will
hear the black rubber gasket in this process on the door hinge move into
the open position. Now your old cylinder lock has been removed, slide
the new lock into the door latch position on the same position. Now
align the new locks so it triggers the black gaskets on the door hinge.
You may understand that it is the reverse of above mentioned process.
Just as we have removed the lock of the door same the way of sliding new
one but in the reverse direction. Now you are going to set the screws
of your lock. It can be done by turning the key. Now, listen the door
hinge to see the black rubber gaskets move. Now you have done so it is
the time to tighten the set screws on the lock. Now turn the door panel
back on and turn the Allen screws to the right side in order to secure
it back to the door.
Always remember that the screws must not be so much tight to give any
damage to the lock. In case of tight screws you may find cracking on
the door panel plastic. To check the wiring follow the directions of the
voltmeter with the new door lock in place. It must not exceed by 2.
Otherwise you may have some problem in your wiring. The process of
changing the lock is exactly right. It must be kept under consideration
that some companies give the warranty of the parts of hire careen case
of such situation you must contact to the company. They have Locksmith phoenix – Expert Locksmith who can change the lock of your car in a proper way. in this
way you may get your car lock repaired and the loss of money that you
have to pay to the locksmith and the cost of lock will be saved.